Switch Panel:

The switch panel accommodates up to 10 switches and is designed to be used in conjunction with Sedgewall's Full Feature Relay Pack. It provides positive latching or momentary illuminated switches, as required, with a choice of background colours. The unit has a fully regulated power supply and interchangeable face plates to enable fitment into a wide range of vehicles. The switches can be set up to operate individual functions such as headlamp flash, 360 blues Alley Lights, siren etc. Additionally, the configuration can be set up to include a number of pre-programmed single button keys to operate functions such as :- 999, "Arrival at Scene" etc. More...

Remote Switch Panel:

The remote switch panel accommodates up to 9 switches, two multi-function switches, a clear all (reset) and a walk test.  It is designed to be used in conjunction with Sedgewall's Full Feature Relay Pack, but can also be used as a stand alone switch panel. It provides tactile illuminated switches with a backlight mode when side lights are operational. The unit has a fully regulated power supply and is supplied with a mounting clip enabling installation in to any vehicle. The two multi function switches are user programmable and can activate any of the nine function switches by a single key press.  ie. 999 can activate blues, headlamp flash and siren. More...

The Battery Voltage Manager/Timer prevents the vehicle's battery voltage dropping to unacceptable levels that can prevent the restart of the vehicle and/or corruption of Radio Transceiver memory. A common cause of low battery voltages occurs when the Radio has been inadvertently left switched on when the vehicle is left unattended. The unit operates by monitoring the battery voltage, if the voltage falls below 10.7V * it cuts off power to the unit it is connected to, thus preventing further draining of the battery. The unit also cuts off power automatically 2 hours after the ignition has been switched off. More...

This is a simple flashing unit suitable for enabling headlamp flash on emergency vehicles. The unit is e marked and fully encapsulated. More...

The multipattern flasher unit is fully programmable and can switch between multipattern flash sequence, alternating flash, pulse fast and pulse slow. This unit also has the ability to stop flashing and give continual power if required. More...

The run lock unit enables a driver to remove the keys from the ignition of a vehicle, but to still leave the engine running. This enables adequate power, without battery drain, to be supplied to Blues and other scene lights at a major incident The vehicle can then be driven off after re-inserting the keys, if the keys are not re-inserted the engine will cut out on removal of the parking brake or activation of the footbrake. This unit has three separate outputs as required on most modern vehicles. More...

This smaller switch panel is a baby brother to the Full Feature switch panel. This is a compact unit offering up to seven switches. The unit has interchangeable front panels to facilitate fitting into different areas in the vehicle's cab including the central air vent. More...

Sedgewall is able to manufacture a range of cable looms and harnesses to your specific requirements and in the past have supplied a range of both simple and complex cable assemblies/looms for both Emergency Service and Military applications. More...

This relay pack consists of four 30A output relays PLUS a horn ring transfer relay. This is a compact unit and ideal of vehicles with lower levels of equipment.